driveshaft angle help!!

[wissemeier05]

hey every body still trying to eliminate all possibilities b4 i go tearin into the t case again. so here it goes

can i get every ones rear driveshaft angle and driveshaft type and if you t-case is dropped.

i have 30degrees on the shaft and 5 degrees on the t-case (measured off the flat spot on yoke)

i read something at school about anythign past 20 is immediate death to the shaft...

TIA
dan :cool:

[olivesta500]

still having troubles with that...?
22 degrees on the shaft, and level on the transfer case output. tom woods driveshaft and AA sye. if your t-case is angled down then youre only 3 degrees more than me.

p.s. dan, what are you doing saturday and sunday the 14 and 15? my jeep is itching to grow :D you could use the welder that day too if youd like.

[OhioYJ]

dan, what are you doing saturday and sunday the 14 and 15? my jeep is itching to growI thought you were ok with your Jeeps height for the time being?

[olivesta500]

Originally posted by OhioYJ:
</font><blockquote>quote:</font><hr />dan, what are you doing saturday and sunday the 14 and 15? my jeep is itching to growI thought you were ok with your Jeeps height for the time being? </font>[/QUOTE]ehh, remember how much i rubbed when flexing in slade? i just got a 1 inch daystar body lift to fix most of that (hopefully). besides mike im not spring over yet tongue.gif :D

[OhioYJ]

mike im not spring over yet :D I thought thats what you were referring too. I have a pre-bent draglink you can have. :D Come on I'll come up and I'm sure between all of us, we'll have you SOA in no time. {DarthVadar Voice}Come to the dark side Bill {/DarthVadar Voice}... :D :D

[wissemeier05]

Originally posted by olivesta500:

p.s. dan, what are you doing saturday and sunday the 14 and 15? my jeep is itching to grow you could use the welder that day too if youd like. yeh i got the days blocked out for u looks like we have all day both days..yay i get to use the welder :D looks like we can finish your diff gaurds and i can finish my gift to erin ;) do the mystrie SYE projects and ur body lift..
i will c if i can get a propane refill cause it gettin low and we use the garage 4 a reason....HEAT

:D the noise has been found it was too sever of a rear drive shaft angle :D


-bill i still and 1/8 bigger :D no wait a 1/4 cause off my frame and shackles ;) ...its ok when i am caughing on gas going down hill you can cruze past me ;) ......**** i cant wait to go to haspin smile.gif

[olivesta500]

alright cool thanks. let me know if you want me to pitch in on a propane refill.

youre proud of that 1/8" arent you? tongue.gif

whats it been? 5 months? you deserve a good wheeling trip. i cant wait either, hopefully its dry...

[wissemeier05]

**** yeh i am dam proud of my 1/8 i bet no one on the board has that same 1/8 i do ;)

yeh it feels like for ever..i cant wait